Flash Cut Instructions:

The Flash Cut System was designed to resurface clean and polish a Bowling Ball in less than 10 minutes!

1st Step: First, Wet Sand the ball up to 320. Then, use a terry cloth towel to apply step 1 Flash Cut in the amount around the size of a half dollar. Spray the Accelerator directly into the body of Step 1 Flash Cut. Spread evenly around the ball surface and turn on your spinner, apply good pressure, allow the ball to polish until it will not get any shinier. Turn off your spinner. (If you want to leave some of the 320 lines in the ball surface do not use the accelerator.) At this point, 90% of the 320 lines should be gone if you used the accelerator. now go to step 2.

2nd Step: Apply Step 2 to a neo tac polishing cloth. (This cloth was designed to create the proper surface friction and will add to the speed of the process.) Again, use an amount about the size of a silver dollar. Spray the accelerator into the body of the Flash Cut Step 2. Spread evenly around the ball surface. Turn on your spinner and apply a good amount of pressure onto the ball surface. Continue polishing until the surface will get no shinier. Turn off the spinner. If some lines remain, repeat step 2 if desired.

3rd Step: If a very high shine is desirable, use neo tac Renew It and our specially designed ultra soft finishing cloths. You wont believe your eyes! A 5000 polish.